Params and Setbackto

[Bl0nkt]

Not sure if this should go in the ganis forum or here. Considering I saw the problem pertain to both, I am putting it here considering this section gets more trafic.

It's simple enough. When using setbackto, params do not transfer with the gani change.

Where this happens:

I'm assuming everywhere, since the two places I have tested this on (Zenkou and Icarus) have had this problem.


Edit: I should also note this.

On Zenkou, I set the gani "zen_hunter_jumpthrust1.gani" with the param "zen_weapon_hunter_empras.png". It shows the param, but as it sets back to "zen_hunter_ready.gani" the param disappears.

On Icarus, this problem does not happen for your client, but can be seen happening to others. When punching, all of your clothes seem to disappear.

[Admins]

I think you can pass params via setbackto, better use gani attributes for that (#P or attr[])

[Bl0nkt]

Here's a little image support.

Screenshots from Icarus:

This is a screenshot of the punch gani.




Here is a screenshot of what happens when the punch gani ends, and sets back to ci_body-idle.gani (setbackto ci_body-idle).



Of course, this happens only when the punch gani ends, and you do not move. If you move, it sets to ci_body-walk.gani and all the params will reappear.

[Admins]

Like I said it's better to use attr[]/#P, that will mean less lag too since it doesn't need to send the gani parameters each time the animation is changed.